Bent Over Two-Dumbbell Row

How to perform

1. 01With a dumbbell in each hand (palms facing your torso), bend your knees slightly and bring your torso forward by bending at the waist; as you bend make sure to keep your back straight until it is almost parallel to the floor. Tip: Make sure that you keep the head up. The weights should hang directly in front of you as your arms hang perpendicular to the floor and your torso. This is your starting position.
2. 02While keeping the torso stationary, lift the dumbbells to your side (as you breathe out), keeping the elbows close to the body (do not exert any force with the forearm other than holding the weights). On the top contracted position, squeeze the back muscles and hold for a second.
3. 03Slowly lower the weight again to the starting position as you inhale.
4. 04Repeat for the recommended amount of repetitions.

Form cues

• —Brace your core before the first rep and keep it braced.
• —Lead with the elbows and finish by squeezing the target muscle.
• —Control the lowering phase — that is where most of the growth stimulus lives.

Common mistakes

• —Using momentum instead of the target muscle.
• —Cutting the range of motion short to add load.
• —Adding weight before the movement pattern is clean.