Jefferson Squats

How to perform

1. 01Place a barbell on the floor.
2. 02Stand in the middle of the bar length wise.
3. 03Bend down by bending at the knees and keeping your back straight and grasp the front of the bar with your right hand. Your palm should be in (neutral grip) facing the left side.
4. 04Grasp the rear of the bar with your left hand. The palm of your hand should be in neutral grip alignment (palms facing the right side). Tip: Ensure that your grip is even on the bar. Your torso should be positioned right in the middle of the bar and the distance between your torso and your right hand (which should be at the front) should be the same as the distance between your torso and your left hand (which should be to your back).
5. 05Now stand straight up with the weight. Tip: Your feet should be shoulder width apart and your toes slightly pointed out.
6. 06Squat down by bending at the knees and keeping your back straight until your upper thighs are parallel with the floor. Tip: Keep your back as vertical as possible with the floor and your head up. Also remember to not let your knees go past your toes. Inhale during this portion of the movement.
7. 07Now drive yourself back up to the starting position by pushing with the feet . Tip: Keep the bar hanging at arm's length and your elbows locked with a slight bend. The arms only serve as hooks. Avoid doing any lifting with them. Do the lifting with your thighs; not your arms.

Form cues

• —Brace your core before the first rep and keep it braced.
• —Drive through the full range — do not cut the lockout short.
• —Set the bar path over mid-foot and keep it there.
• —Control the lowering phase — that is where most of the growth stimulus lives.

Common mistakes

• —Using momentum instead of the target muscle.
• —Cutting the range of motion short to add load.
• —Adding weight before the movement pattern is clean.