Standing One-Arm Dumbbell Triceps Extension

How to perform

1. 01To begin, stand up with a dumbbell held in one hand. Your feet should be about shoulder width apart from each other. Now fully extend the arm with the dumbbell over your head. Tip: The small finger of your hand should be facing the ceiling and the palm of your hand should be facing forward. The dumbbell should be above your head.
2. 02This will be your starting position.
3. 03Keeping your upper arm close to your head (elbows in) and perpendicular to the floor, lower the resistance in a semicircular motion behind your head until your forearm touch your bicep. Tip: The upper arm should remain stationary and only the forearm should move. Breathe in as you perform this step.
4. 04Go back to the starting position by using the triceps to raise the dumbbell. Breathe out as you perform this step.
5. 05Repeat for the recommended amount of repetitions.
6. 06Switch arms and repeat the exercise.

Form cues

• —Drive through the full range — do not cut the lockout short.
• —Control the lowering phase — that is where most of the growth stimulus lives.

Common mistakes

• —Using momentum instead of the target muscle.
• —Cutting the range of motion short to add load.