Weighted Bench Dip

How to perform

1. 01For this exercise you will need to place a bench behind your back and another one in front of you. With the benches perpendicular to your body, hold on to one bench on its edge with the hands close to your body, separated at shoulder width. Your arms should be fully extended.
2. 02The legs will be extended forward on top of the other bench. Your legs should be parallel to the floor while your torso is to be perpendicular to the floor. Have your partner place the dumbbell on your lap. Note: This exercise is best performed with a partner as placing the weight on your lap can be challenging and cause injury without assistance. This will be your starting position.
3. 03Slowly lower your body as you inhale by bending at the elbows until you lower yourself far enough to where there is an angle slightly smaller than 90 degrees between the upper arm and the forearm. Tip: Keep the elbows as close as possible throughout the movement. Forearms should always be pointing down.
4. 04Using your triceps to bring your torso up again, lift yourself back to the starting position while exhaling.
5. 05Repeat for the recommended amount of repetitions.

Form cues

• —Brace your core before the first rep and keep it braced.
• —Drive through the full range — do not cut the lockout short.
• —Control the lowering phase — that is where most of the growth stimulus lives.

Common mistakes

• —Using momentum instead of the target muscle.
• —Cutting the range of motion short to add load.
• —Adding weight before the movement pattern is clean.