Weighted Squat

How to perform

1. 01Start by positioning two flat benches shoulder width apart from each other. Stand on top of them and wrap the weighted belt around your waist with the amount of weight you feel comfortable with. Make sure your toes are facing out.
2. 02Once you are standing straight up with the weight hanging in between your legs, position your arms so that they are fully extended to the side of your body. This is the starting position.
3. 03Begin by bending the knees as you maintain a straight posture with the head up. Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees (which is the point in which the upper legs are below parallel to the floor). Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that are perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
4. 04Begin to move the body back up by pushing the floor of the flat bench with the ball of your foot mainly as you straighten the legs again and go back to the starting position. Exhale as you perform this portion of the exercise.
5. 05Repeat for the recommended amount of repetitions.

Form cues

• —Brace your core before the first rep and keep it braced.
• —Drive through the full range — do not cut the lockout short.
• —Control the lowering phase — that is where most of the growth stimulus lives.

Common mistakes

• —Using momentum instead of the target muscle.
• —Cutting the range of motion short to add load.
• —Adding weight before the movement pattern is clean.